Operation - Honeywell BH-860E Gebrauchsanweisung

I3047.00 BH-860/861/862E OM.1
LCD display will appear a lit-
tle moon. When you press a
13
second time the button
the night reduction is switched
off and the little moon on the
display disappears.
4. Continuous
When you press the button
it is possible to switch the unit
over to a continuous run. That
means that the unit will operate
without the humidistat control
until the tank is empty. On the
LCD display will appear a cir-
cle. When you press again the
8
button , the unit will switch
over to the automatic humidis-
tat control mode and on the
LCD display the circle will dis-
appear.
5. Desired humidity
When a comfortable humidity
level is reached, lower the
humidity level (Humidistat) set-
ting slowly until the electronic
for fog production shuts off.
The desired humidity sign
on the display will appear,
indicating that the humidity set-
ting has been reached. The
electronic humidistat will auto-
matically restart the electronic
for fog production each time
the humidity level falls below
this setting. This "ON/OFF"
cycle will continue periodically
while the humidifier is in use.

Operation

lPlace the unit on a level,
dry surface that is insensitive
to water. Ensure that the air-
filter vents 1 have enough
room for suction. The atomiz-
er nozzle 3 must be unim-
peded in blowing off and
must not be directed against
objects or surfaces in the
immediate vicintity.
lRemove the tank lid
4
fill the water tank
5
with cold, fresh tap water.
l IMPORTANT
Please do not overfill the tank
you can damage the unit.
Please fill tank only to the
"max." sign shown on the
scale. In case that the scale is
missing in the tank, the water
level must be at least 1 cm
under the edge of the tank.
lBefore mounting the
05/09/2006 14:19
enclosed decalcifying filter
6 on the tank filter neck,
, remove the packing sheeting.
Attach the decalcifying filter
on the tank filter neck, align
it along the guide rail inside
the tank and press it down to
the stop. When the filter is
8
,
now under the water, please
press the knob of the integrat-
ed valve of the filter down to
allow the air bubbles to
escape. Please do this proce-
dure everytime you replace
the filter. We recommend to
press the knob of the integrat-
ed valve also once in a week
for better function of the filter.
lReplace the tank lid
5
the water tank .
lMount the atomizer nozzle
3
and turn it in the desired
direction.
lConnect the unit to the
power supply system with the
plug.
lSet the humidity control to
your favorite value for contin-
uous adjustment of the
desired humidity. The opti-
mum value between 40%
and 60% is easy to adjust.
You press the button
12
together and
after some seconds on the
LCD display the current value
of humidity starts to flash.
Now it is possible to adjust
with the button or with the
button the value of humidity
you want. After a few sec-
onds your chosen humidity
value disappears and the dis-
play switches over to the cur-
rent humidity value of your
room. This setting is automati-
cally maintained by your
humidifier, which means: if
the air is too dry the humidifi-
and
er will sense and automatical-
ly cycle on. When the
desired humidity is attained,
the unit switches off automati-
cally.
lIf the water tank 5
empty, the unit switches to a
standby position. This is indi-
cated by the red signal light
10
"Add water". In this
case, add water.
lIf you have a unit with night
lowering, you can set this
Page 14
4 on
11
and
is