Pioneer CT-W205R Bedienungsanleitung Seite 20

TROUBLESHOOTING
Symptom
POOR SOUND QUALITY
Unstable or interrupted
No high frequencies
H i g h f r e q u e n c i e s a r e
emphasired.
Sound from previous
recordings remains when
rerecording a tape.
The Sound is distorted.
Too much noise
OTHERS
The music search function
does not work.
Cannot use the remote
control System.
Abnormal functioning of this uni? may be caused by stark electricity, or other extemal interference, To restore normal Operation, turn the
power off and then on again, or unplug he AC power Cord and then plug it in again.
20
En
Cause
The head, pinch rollers and capstans are dirty.
l
The tape is not uniformly wound.
l
l A tape recorded without Dolby NR is being played
back with the DOLBY NR switch in the B or C
Position.
The head is dirty.
l
A Dolby NR-encoded tape is being played back
l
with the DOLBY NR switch in the OFF Position.
The headisdirty.
l
Recording level is too high.
l
The recorded Signal itself is distorted.
l
The head is dirty.
l
High noise tape is being used.
l
Incomplete insertion of a connection Cord, poor
l
contact.
Recording level is too low.
l
The head is dirty.
l
The head is magnetized.
l
Blanks between selections are less than
l
4 seconds long.
The control cord is not connected.
l
Remedy
Completely fast-forward or rewind the tape.
l
Set the DOLBY NR switch to OFF.
l
Clean the head bee page 5).
l
Set DOLBY NR(B/C) switch to the same Position
l
Clean the head bee page 51.
l
Turn REC LEVEL control down when recording
l
Replace the cassette.
l
l Clean the head (See page 5).
Replace the cassette.
l
Check connections (sec page 6).
l
Turn REC LEVEL control up when recording
l
Clean the head (sec page 51.
l
l Demagnetize with a head demagnetizer
Use a tape with blanks more than 4 seconds long.
l
Connect the control cord (sec page 6).
l