Troubleshooting; Disposal - VOLTCRAFT VC610BT Bedienungsanleitung

19.

TRoUBLESHooTING

In purchasing the DMM, you have acquired a product designed to the state of the art that is
operationally reliable.
Nevertheless, problems or errors may occur.
For this reason, the following is a description of how you can easily remove possible malfunctions
yourself:
Always follow the safety instructions!
Error
The multimeter does not work.
No measured value change.
The meter beeps and the
"WARNING!" symbol flashes
20.

DISPoSAL

Product
Electronic devices are recyclable waste and must not be disposed of in the household
waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from the
product.
54
Possible cause
Is the battery dead?
Is the power cord connected
correctly?
Is a wrong measuring
function active (AC / DC)?
Are the measuring leads
inserted tightly into the
jacks?
Is the fuse defect?
Is the HOLD
activated (display "H")
Incorrectly connected
unsuitable measuring leads.
Remedy
Check the status.
Replace the battery.
Check the power cord.
Check the display (AC / DC)
and switch the function if
required.
Check the proper an fit of the
measuring leads.
Check the fuses.
function Press the "HOLD button" (9) to
deactivate this function.
or Connect
properly to the meter or change
the measuring function.
measuring leads