Overview; Safety Information; Graphical Symbols On The Device; Technical Specifications - Parkside PHS 29 A1 Originalbetriebsanleitung

Overview

1 High pressure connection on the gun side
2 Cap nut
3 Top extension pipe
4 Bottom extension pipe
5 Cap for cleaning agent tank
6 Brush
7 Pull-out lip (replaceable)
8 Cleaning agent dose controller
9 Adapter
10 Cap nut adapter

Safety information

Also observe the safety instruction
for your pressure washer.
Pressure washers can be dan-
gerous if used incorrectly. Do
not direct the jet at people, ani-
mals, live electrical equipment or the
equipment itself.
• To prevent damage, please also note
the manufacturer's instructions for the
object being cleaned.
• Use only original accessories and do
not carry out any modifications.
Graphical symbols
on the device
Read the operating instructions.

Technical specifications

Pressure washer brush attachment:
Suitable for high pressure cleaners with the
following performance data:
Rated pressure (p). .....11 MPa / 1595 psi
Max. pressure (p max) .16 MPa / 2320 psi
Max. flow rate (Q max) .............. 450 l/h
Max. inlet
temperature (T max) .......... 60 °C / 140 °F
Cleaning agent tank filling level ...... 210 ml

Initial Operation

Assembly:
1. Screw the brush (6) onto the bottom
extension pipe (4).
2. Screw the bottom extension pipe (4)
onto the top extension pipe (3).
Connecting without adapter:
1. Plug in and twist (Bayonet locking devi-
ce) to connect the pressure scrubber to
the spray gun of your PARKSIDE pressu-
re washer via the high pressure connec-
tion on the gun side (1).
2. Screw the cap nut (2) against the spray
gun for a firm grip.
Connecting with adapter:
1. Attach the adapter (9) to the high-pre-
ssure connection (1) and turn it through
90° until it locks into place (bayonet
locking device).
2. Screw the cap nut (2) on to the upper
extension tube (3) against the adapter
(9).
3. Connect the spray gun of the high
pressure cleaner (bayonet locking de-
vice) and screw the cap nut (10) of the
adapter (9) against the spray gun.
On all surfaces, test the brush (6)
initially on a location that is not
visible, in order to ensure compati-
bility.
Disconnecting:
Removal of the pressure scrubber is in the
reverse order.
GB IE NI
5