Maintenance; Troubleshooting - Klarstein 10012217 Bedienungsanleitung

 What contained in fold or getting into air inside the refrigerator by opening doors may form a layer
of frost inside. It will weaken the refrigerator when the frost is thick while it is more than 2mm
thick, you should defrost.
 Defrosting in freezer chamber is operated manually. Before defrosting, take the food, the ice tray
and the shelf out into the cold storing chamber separately, then set the knob of the temperature
regulator to position"0"(where the compressor will stop working and leave the door open unit ice
and frost dissolve thoroughly deposited at bottom of the freezer chamber) wipe off the water with
soft cloth in the case of speeding up the defrosting. You may put a bowl of warm water (about
50℃) into the freezer chamber and be sure to set the knob of the temperature regulator to
original position after defrosting.
 It's inadvisable to be heat freezer chamber directly, with hot water or high dryer while defrosting
to present deformation of the inner case.
 It's also inadvisable to scrape of ice frost or separate food from the containers which have been
congealed together with the food with sharp load or wooden bars. So as not to damage the inner
casing or the surface of the evaporator.
 If the supply cord of the appliance is damaged, it must only be replaced by a repair shop appointed
by the manufacturer. Because special purpose tools are required.
 The refrigerator should be cleaned and maintained once a month.
 When performing maintenance, make absolutely sure that the power plug is first disconnected
from the power outlet.
 Wipe the inner and outer surface of the refrigerator and its accessories with wet cloth, if they are
too dirty, scrub them with neutral detergent and then clean them with water and dry them with
clean cloth. After this, a small quantify of glass wax is recommended to polish the refrigerator
surface with a flannelette.
 For cleaning don't use hot water, diluent, petrol, alcohol, kerosene, washing powder, cleanser,
aikallinous detergent, acid, chemical cloth, etc. So as not damaged the lacquer coat and plastics.
It is forbidden than the refrigerators directly with water. Otherwise, it would cause rusty or
weaken the insulation.
 Be careful to upkeep the sealing rubber bars of the doors. They should always be cleaned.
 When the refrigerator does not work. Check if there is a power failure. Check if the power plug
u=is plugged into power outlet.
 When the refrigerator is cooling excessively. The temperature control dial may be set too high.
 If you place foodstuffs containing a lot of moisture directly under the cool air outlet, they will
freezer easily. This does not indicate a malfunction.
 When the refrigerator is not cooling sufficiently. The food may be packed too tightly together
which will block the flow of cool air. You may have put something hot or a lot of foodstuffs into the
refrigerator.
 The door may not have been closed properly. The door gaskets may be damaged. The refrigerator
may not be ventilated. There may be insufficient clearance between the refrigerator and the
surfaced immediately both sides and above. The temperature control dial may not be set properly.
When the defrosting water overflows inside the refrigerator and onto the floor. Checks that the
drain pipe and drain hose are not clogged. Check that the drain pan is house properly.
 When the refrigerator's cabinet front heats up. In order to safeguard against condensation, there
is an anti condensation pipe which heats up the cabinet front when running actuated. A warm
cabinet front does not indicate a malfunction.
Cautions

Maintenance

Trouble shooting
8