Service; Safety Instructions For Motor Carving Devices; Original Accessories / Additional Equipment; Operation - Parkside PSG 50 B2 Originalbetriebsanleitung

cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.

5. Service

a) Have your device repaired at the ser-
vice centre or by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
Safety instructions for
motor carving devices
In order to avoid injury, fire and health
hazards:
S ecure the work piece. Use clamping
devices / a vice to hold the work piece.
It is then held more securely than with your hand.
Wear protective goggles!
There is a danger of injury from
splintering materials flying into your
eyes etc.
Wear a dust mask! During pro-
longed working with wood and par-
ticularly if materials are processed
which produce dusts that are hazardous to the
health.
D o not soak materials or areas which
are to be worked on with solvent-con-
taining liquids. Shaving of the materials may
produce harmful / toxic vapours.
M aterial containing asbestos must not
be processed with this device. Asbestos
is a known carcinogen.
U nder no circumstances should you prop
up your hands next to or in front of the
General safety advice for electrical power tools / Operation
device or the area to be worked on.
There is a danger of injury from the very sharp
attachment tools.
A lways route the cable towards the back away
from the device.
I n cases of danger remove the plug from the
socket immediately.
Original Accessories /
Q
Additional Equipment
U se only the accessories and additional
equipment referred to in the instruc-
tions. The use of tools or other accessories
which are not recommended in the instructions
may represent a risk of injury.

Operation

Q

Turning the Device On / Off

Q
I nsert the mains plug into a socket.
Switching on:
P ress the ON / OFF switch
Switching off:
P ress the ON / OFF switch
Inserting / replacing
blade inserts
RISK OF INJURY! Switch the
device off and pull the plug out of the mains socket
before carrying out any work on the device.
RISK OF INJURY! The blade
inserts have very sharp cutting edges.
7
Wear appropriate protective gloves
when inserting and testing the blade.
The choice of blade insert
ded task. The supplied blade inserts
for a wide range of common uses (see Fig. B–D).
to the "I" position.
1
to the "0" position.
1
depends on the inten-
7
are suitable
7
GB/IE 9