Installing The Dust Extraction Hood; Adjusting The Dust Extraction Hood; External Extraction; Operation - Parkside PSR 310 A1 Originalbetriebsanleitung

Installing the dust extraction
hood (see Fig. E)
Insert the dust extraction hood
fastening grooves
16
slight resistance.
Tighten the clamping screw
traction hood is now firmly installed on the
2
tool arm .
15
Adjusting the dust extraction
hood (see Fig. F)
Adjust the dust extraction hood
sparks are not directed at the user.
The dust extraction hood
grinding spindle from various angles. Use the
locking grooves
17
Following installation, rotate the dust extraction
hood toward the handle
2
the application and the work piece. The dust
extraction hood
2
eral positions.

External extraction

EXPLOSION HAZARD!
A special dust extractor must be used for explosive
dust / air mixtures.
FIRE HAZARD DUE TO SPARKING! Do not
use dust extraction when working on metal.
FIRE HAZARD! Using power
tools which can be connected to a vacuum using a
dust extraction poses a fire hazard! Unfavourable
conditions, e.g. sparking - when grinding metal or
metal pieces in wood - can ignite wood dust inside
the vacuum bag. This can particularly occur if the
wood dust is mixed with paint particles or other
chemicals and the ground product is hot after long
work periods. Therefore be sure to avoid the ground
materials and the device from overheating and al-
ways empty the vacuum bag before taking breaks.
Wear a dust mask!
into the two
2
on the tool arm against
15
. The dust ex-
4
so dust or
2
can cover the
2
for this purpose.
according to
6
will lock into place in sev-
Connecting the dust extraction hose
Slide the vacuum adapter
piece (see Fig. G).
3
Slide the hose from a reliable dust extraction
(e.g. a workshop vacuum) into the vacuum
adapter .
9
Removing the dust extractor hose
Pull the hose out of the dust extraction unit.

Operation

RISK OF INJURY! Always
unplug from the mains before working on the sand-
ing brush.
Firmly hold the power tool with both hands whilst
working and ensure a solid stance. Holding the
power tool with both hands is safer.
Note the mains voltage! The voltage of the pow-
er source must correspond with the specifications
on the type plate of the power tool.

Switching on / off

To switch on the power tool, slide the on / off
switch forward so the switch shows "1".
7
To save power, only switch on the power tool
when in use.
To switch off the power tool, slide the on / off
switch back so the switch shows "0".
7
Check the grinding tool before use.
The grinding tool must be properly installed
and rotate freely. Perform a test run of at least
1 minute without load. Do not use damaged,
untrue vibrating grinding tools. Damaged
grinding tools could burst and cause injuries.

Selecting the grinding tool

Select the grinding tool according to the shape of
surface to be worked on and the material to be sand-
ed. Match the grit with the desired material removal.
Start-up / Operation
into the connecting
9
GB/IE 11