Hitachi CL32W30TAN Wartungshandbuch Seite 309

RF OUT
AV2
AV2 scart input
Use this to connect digital video
broadcasting equipment, home
computers and home entertainment
systems to your TV. Output from this
connector can be selected. See AV
RF aerial socket
This should be
permanently connected to
an RF source - i.e your
aerial antenna.
Use these connections to attach your leads to the amplifiers and speakers:
Once connected de-activate 3DS system (see page 28) and set Speaker Setup to WIDE or NORMAL
mode (see page 30) - with this configuration, using 5 external speakers full Dolby Pro Logic can be
achieved enhancing your viewing and listening experience.
...notes on audio equipment
If you have purchased your TV complete with Hitachi's power console please refer to the Users
Your HITACHI dealer can also advise you on the correct amplifier and speaker choice for your TV.
SERIAL PORT
C.1
LINE
C.2
AV2 AV1
S
R
AV1 AUDIO LINE OUT
AV1 scart input
Use this socket to
connect ordinary VHS,
S-VHS or Hi8 equipment
to your TV. It is also used
for digital output.
setup on page 32.
quad phono sockets
S is for the surround amplifier and speakers
C is for the centre amplifier and speaker
R is for the right amplifier and speaker
L is for the left amplifier and speaker
Guide supplied with the equipment.
2 X 12W 8
C R L
S
L
R
AUDIO LINE OUT
2 X 12W 8
R L
C
L
DIN sockets
external speakers for which
no amplifier is necessary.
R is for the right external
speaker, and L is for the
output socket is specifically
designed for HITACHI
accessories - under no
circumstances connect any
other accessory to this
socket as this could cause
irreparable damage to your
Before connecting
external equipment,
please consult
AV setup on page 32.
The DIN sockets are
used to connect two
left external speaker.
18V socket
The 18V power
equipment.
11