Handling The Wall Grinder; Maintenance And Cleaning - Parkside PMNF 1350 B2 Originalbetriebsanleitung

NOTE
GB
► When setting a cut width that is smaller than
IE
the maximum cut width, you must use the in-
termediate layers on the fixing flange side for
fixing the cutting discs since the fixing flange
cannot fix the discs alone on the spindle due
to the thread length (see fold-out page).
NOTE
► Replace diamond cutting discs only in pairs.

Handling the wall grinder

CAUTION!
► This appliance is designed for dry cutting only!
♦ Use a service line detector to check the internal
and external walls for concealed power, gas and
water supply lines before using the wall chaser.
♦ Select the desired groove width.
♦ 1.) Position the appliance with the roller
against the brick wall.
♦ 2.) Now switch the appliance on and plunge
it into the masonry until the stop
contact.
♦ 3.) Then mill the groove in the masonry; pay
attention to the milling direction. The appli-
ance must always run in reverse rotation.
Otherwise the appliance could be pushed
out of the cut in an uncontrolled manner.
2
♦ At the end of the groove, swivel the appliance
out of the groove and only then switch the
appliance off.
♦ Now break out the resulting bar between the
two grooves using the hand chisel
8
makes
3
1
.
CAUTION!
► Materials containing asbestos must not be
machined!

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before commencing
any work to the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
WARNING! If the connecting cable
needs to be replaced, this must be
carried out by the manufacturer or
an authorised representative in order
to avoid safety hazards.
■ Grinding tools are to be treated with care and
transported carefully. Grinding tools should be
stored in such a way that they are not exposed
to mechanical damage or harmful environmental
influences.
■ Never allow liquids to get into the appliance.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
PMNF 1350 B2