Supplementary notes
Approved cutting disc designs:
Diamond-coated, disc diameter 125 mm, disc
thickness max. 2.2 mm
Wear hearing protection!
Wear safety goggles!
Wear safety shoes!
Wear protective gloves!
Wear a dust mask!
Not approved for wet grinding!
Original accessories/auxiliary equip-
ment
■
Only use the accessories and additional equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
Before use
Setting the groove depth
♦
Loosen the locking screw
♦
Set the depth stop
♦
Tighten the locking screw
Attaching the dust extraction ad-
apter
♦
Push the pins of the dust extraction adapter
into the recesses on the dust extraction connector.
♦
Lock the dust extraction adapter
it.
♦
Loosen the union nut
♦
Push the pipe of the extraction device far enough
into the opening on the union nut
♦
Tighten the union nut
PMNF 1350 B2
.
to the desired depth.
.
by turning
.
.
fully.
Operation
Switching on and off
NOTE
►
Always switch the appliance on before making
contact with the material, then apply it to the
workpiece. The wall grinder is equipped with
an electronic smooth start. The motor starts
with a delay.
Switching the appliance on:
♦
Activate the safety lock-out
page). Then press the ON/OFF switch
Switching the appliance off:
♦
Release the ON/OFF switch
Attaching and setting the cut width of
the diamond cutting discs
♦
Loosen the locking screw
♦
Push the depth stop
♦
Press the spindle lock
♦
Use the face spanner
flange
.
♦
Remove the mounting flange
♦
Set the desired cut width in accordance with the
number of intermediate layers
the centring flange
intermediate layer.
NOTE
►
There are several spacer washers available
for you. Ensure that the groove width is the total
of the spacer washers between the diamond
cutting discs and the thickness of the cutting
discs.
♦
Tighten the mounting flange using the face
spanner
. Press the spindle lock while doing
this.
(see fold-out
.
.
.
upwards.
and hold it down.
to loosen the mounting
.
. Ensure that
is set in place as the top
GB
IE
7