Safety Regulations; Layout And Items Supplied; Proper Use - EINHELL DMH 250/2 Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Take suitable precautions to protect yourself and
your environment from potential hazards.
•
Never put the chisel hammer to any use other
than that intended.
•
Be careful with combustible materials. Sparks
may be caused by impact.
•
Keep pneumatic tools safe from children.
•
Always concentrate while you work. Do not
work if you are tired.
•
Use only a quick-release coupling to connect
up the air supply.
•
It is imperative to use a pressure reducer to
set the working pressure.
•
Never use oxygen or combustible gases as
an energy source.
•
Never allow the tool to run unloaded at full
idle speed.
•
Always disconnect the tool from the air supply
before carrying out any repairs or mainte-
nance work.
•
Use only original replacement parts.
•
Wear the necessary protective clothing, parti-
cularly goggles, ear-muffs and safety gloves,
when working with the chisel hammer.
GB

2. Layout and items supplied

2.1 Layout (Fig. 1)
1 trigger lever
2 air regulating screw
3 cylinder
4 clamping spring
5 plug-in nipple for air supply
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Pneumatic Chisel Hammer
•
clamping spring
•
Original operating instructions

3. Proper use

The chisel hammer is a pneumatic tool for general
use. It can be used, for example, to cut grooves,
to remove tiles or plaster, to knock holes through
walls, to cut metal sheet and plate, and to knock
off bolts and rivets.
The exhaust air leaves the housing to the front.
- 14 -