Original Accessories/Auxiliary Equipment; Operation; Switching On And Off; Setting The Oscillating Speed - Parkside PSS 250 A1 Originalbetriebsanleitung

Original accessories/auxiliary
GB
equipment
IE
CY
■
Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury.

Operation

Switching on and off
Switching to instantaneous operation:
♦ Press the ON/OFF switch
Switching off instantaneous operation:
♦ Release the ON/OFF switch
Switching to continuous operation:
♦ Press the ON/OFF switch
pressed in and then press the lock button
Switching off continuous operation:
♦ Press the ON/OFF switch

Setting the oscillating speed

You can set the desired oscillating speed using the
speed selector
depends on the material being processed and can
be determined through practical tests.

Fitting the sanding sheet

WARNING!
► Always remove the plug from the mains power
socket before carrying out any work on the
appliance.
NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding pad
6
.
.
and keep it
and release it.
as required. The required speed
Sanding sheets with Velcro:
♦ Position the sanding sheet
of the sanding pad
♦ Then place the sanding sheet
pad
Sanding sheets without Velcro:
♦ Open the two clamping levers
♦ Push the sanding sheet
clamping rail
in place with the clamping lever
♦ Follow the same procedure at the other end.
Different materials require different grain sizes. You
can find out which grain is suitable for which work
in our non-binding recommendations in "Work
instructions, tips and tricks".

Extracting dust

WARNING! RISK OF FIRE!
.
► When working with power tools fitted with a
dust collector
to a vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust bag (or in the bag of
the vacuum cleaner) can spontaneously ig-
nite. This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after be-
ing worked for a long time. Therefore, do not
allow the workpiece to overheat and always
empty the dust collector
in the vacuum cleaner before taking a break
from work.
Wear a dust mask!
, remove
.
flush on one side
.
and press it firmly into place.
under the open
at one end and clamp it firmly
or which can be connected
or the dust bag
on the sanding
.
.
PSS 250 A1