Service; Appliance-Specific Safety Instructions - Parkside PSS 250 A1 Originalbetriebsanleitung

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b) Always arrange for the plug or the power
cord to be replaced by the manufacturer of
the appliance or by its approved customer
services. This will ensure that the safety of the
power tool is maintained.
Appliance-specific safety instructions
To avoid the risk of injury or fire as well as
health risks:
■ When working outdoors, connect the appli-
ance via a fault current circuit breaker with
a maximum tripping current of 30 mA.
■
Use only an extension cable approved for
outdoor use.
■ Secure the workpiece. Use clamps/vice to
hold the workpiece firmly in place. This is
safer than simply holding it in your hand.
■ In case of danger, remove the plug from the
socket immediately.
■
Always route the power cable towards the
rear, away from the appliance.
■ RISK OF FIRE DUE TO FLYING SPARKS!
If you sand metal, sparks will be produced.
Ensure that nobody can be put at risk and that
no combustible materials are located in the
immediate vicinity of where you are working.
WARNING! TOXIC DUSTS!
► Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health.
Contact with or inhalation of these dusts can
represent a health hazard for the person op-
erating the appliance and any other people
in the vicinity.
PSS 250 A1
WARNING!
RISKS DUE TO DUST!
► When working for extended periods on
wood and, in particular, materials that pro-
duce dusts that are hazardous to health, con-
nect the appliance to an appropriate external
dust extraction appliance. Wear safety gog-
gles and a protective dust mask!
■ Ensure sufficient ventilation when working on
plastics, paints, lacquers, etc.
■ Do not soak the materials or the area to be
processed with liquids containing solvents.
■ Avoid sanding lead paint or other harmful
materials.
■ Materials containing asbestos may NOT be
processed. Asbestos is a known carcinogen.
■
The device is designed for the dry surface
sanding of wood, plastic, metal and plaster
and painted surfaces.
■ Never work on moistened materials or damp
surfaces. Water entering a power tool will in-
crease the risk of electric shock.
■ Always hold the appliance firmly with two
hands while working.
■ Do not rest your hands next to or in front of
the appliance and the area being worked as
there is a risk of injury if you slip.
■
Always switch the appliance off and allow the
sanding sheet to stop oscillating before put-
ting the orbital sander down.
■
Always remove the plug from the power socket
during work breaks, when adjusting the appli-
ance (e.g. changing the sanding sheet) and
when it is no longer in use.
■ The appliance must always be kept clean,
dry and free from oil or grease.
GB
IE
CY
5