IKEA KULINARISK Handbuch Seite 29

ENGLISH
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to remove
it.
7. Hold the door glass panels by their top
edge and carefully pull them out one by
one. Start from the top panel. Make sure
the glass slides out of the supports
completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
When the cleaning is completed, install the
glass panels, the door trim and the oven
door, close the levers on the both hinges.
Make sure that you put the glass panels (A,
B and C) back in the correct sequence.
1
Check for the symbol / printing on the side
of the glass panel, each of the glass panels
looks different to make the disassembly and
assembly easier.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones is
not rough when you touch it.
When installed correctly the door trim clicks.
A B C
Make sure that you install the middle panel
of glass in the seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of
the oven. It prevents damage to the lamp
glass cover and the cavity.
29
A
B
C