Operation after Learning Mode
1. Select the transmission range 1, 2 or 3 and press the EIN/ON
key of group A in order to turn on the receiver. By pressing the
key AUS/OFF of group A you will turn off the receiver.
2. By pressing the EIN/ON key of group B in the 2
range, you will switch on the second receiver and by pressing
the AUS/OFF key you will switch off the receiver.
Deactivating the optional available Motion Detector
Despite of day and night and whenever desired, you can use the
remote control to deactivate the optional available motion detector,
so the lantern and/or the floodlight does not turn on when move-
ment from the motion sensor is detected.
Example: In the field of vision of the motion detector persons or
animals walk up and down so the lantern and/or the floodlight
permanently turn on. With the remote control you can deactivate the
motion detector for an indefinite period of time.
The lantern is operated in the 1
pair of keys of group A. Make sure to stay within the transmission
range.
st
1. Set the 1
AUS/OFF keys of group A simultaneously. Press the key as long
as the LED of the remote control and the LED (5) turns off. Now
the motion detector is deactivated.
Now the lantern can only be switched on and off with the remote
control and the radio switch, but not with the motion detector.
2. To activate the motion detector, press the EIN/ON key of the
group A or the ON section of the radio switch.
3. Finally switch off the lantern with the remote control or the radio
switch so the lantern will be switched on again with detected
movement of the motion detector.
transmission range and press down the EIN/ON and
Operation
st
transmission range and with the
16
nd
transmission