Westfalia 96 11 02 Bedienungsanleitung Seite 19

Learning the Lantern, Type ED102
1. To send the command to the
lantern, hold the remote control
and the lantern close together.
Hold the learning key pressed that
way (preferably form the side), in
order to be able to notice the
status of the built-in LED.
2. Press the learning key down as
long as the LED starts flashing.
Now you have totally 30 seconds
to emit the command signal.
3. First select the transmission range
1, 2 or 3. Decide if you want to turn on and off the lantern with
the pair of keys from group A or group B. In this example select
st
1 transmission range and the pair of keys of group A.
4. Hold the AUS/OFF key of group A as long as the LED of the
learning key and the LED (5) of the remote control turns off. Now
the command signal is emitted.
5. Now the lantern can be operated with the pair of keys of group A
st
in the 1
lantern with the pair of keys of group B, or to change the trans-
mission range, repeat the above mentioned steps, starting from
point 1.
transmission range. If you want to turn on and off the
Learning
Learning Key
14