Parkside PFDS 33 A1 Originalbetriebsanleitung Seite 30

♦ Push the flux-core wire through the wire feed guide C (see fig. 9).
Fig 9
♦ Guide the wire along the feed roll G and then push it into the cable
assembly opening I (see fig. 10).
Fig. 10
♦ Swivel the press roller unit E in the direction of the feed roll G
(See fig. 11).
♦ Hook the adjustment screw D into place (see fig. 11).
♦ Set the adjustment screw so that the welding wire sits firmly between
the press roller and the feed roll G in the upper guide without being
pinched (see fig. 11).
Fig. 11
♦ Switch on the welder using the main switch
♦ Press the torch button .
Now the wire feed system pushes the welding wire through the cable
assembly and the torch
│ GB │ MT
■ 26
.
.
♦ As soon as the wire juts 1–2 cm out of the torch neck M, release the
torch button (see fig. 12).
Fig. 12
♦ Switch off the welder.
♦ Screw the flow nozzle back on.
Make sure that the flow nozzle
welding wire being used (see fig. 13).
With the supplied welding wire (Ø 0.9 mm) the flow nozzle
must be used with the next largest diameter of 1.0 mm .
Fig. 13
♦ Push the torch nozzle back onto the torch neck M with a turn to the
right (see fig. 14).
Fig. 14
WARNING!
► To avoid the danger of electric shock, injury or damage:
– Before maintenance or pre-work preparation activity,
always disconnect the mains plug from the mains
power socket.
matches the diameter of the
PFDS 33 A1