Making An Audio Recording; To Set For Automatic Standby Status (Auto Power Down); Restoring All The Settings To The Factory Default Settings - Pioneer A-10-K Bedienungsanleitung

Operation

Making an audio recording

You can make an audio recording from any audio source connected to the amplifier.
SACD/CD player
Network audio player
/I STANDBY/ON
STANDBY PURE AUDIO Hi-Bit 32
iPod/USB
5V 2.1A
Audio recording component
(CD recorder, tape deck, etc.)
1 Select the source you want to record.
SACD/CD NETWORK PHONO
TUNER AUX
2 Start recording, then start playback of
the source component.
iPod dock, etc
Turntable
iPod
Music>
Extras>
Settings>
Shuffle Songs
Backlight
Tuner
MENU
N-50
NETWORK AUDIO PLAYER  
FUNCTION  
  
Playback
Recording 1

To set for automatic standby status (Auto Power Down)

When this condition is set, if no input signal is detected for 30 minutes, the unit will automatically enter standby
status.
1 If the unit's power is ON, hold the unit's front-panel DIRECT button and LOUDNESS
button depressed simultaneously for three seconds.
When this condition is set to ON, the STANDBY/APD indicator on the unit's front panel will light green. Press the
buttons again to disable the setting.
• This condition can also be set by means of the APD button on the A-30's remote control.
• The factory default setting is ON.
Note
• Depending on the device connected, excessive noise produced by the device may be interpreted as an audio
signal, thus preventing the Automatic Power-Down function from operating.

Restoring all the settings to the factory default settings

1 When power is in standby mode, hold the front-panel's DIRECT button and
SPEAKERS A button depressed simultaneously for five seconds.
2 Turn power ON to the unit.
04
11
En