Connections; Line Level Connection; Connecting The Power Cord; Operation - Pioneer s 71w Bedienungsanleitung

CONNECTIONS

Before making or changing any
connections, switch off the power and
disconnect both this unit and the
amplifier/receiver from the AC outlet.

LINE LEVEL CONNECTION

Rear Panel Supplied RCA plug cord
Connect the set's LINE IN terminal to the
amplifier or receiver's SUBWOOFER PREOUT
terminal using the included RCA pin cord.
NOTE:
• When connected to the PREOUT terminal
for surround center channel on the
amplifier or receiver, the bass is heard only
on the center channel, so it will be
insufficient.
CONNECTING THE POWER
CORD
Power cord
Connect the power cord for this unit to the
unit's power connector (AC IN), and the other
ends to an AC power supply. When turning on
the power, turn on the power to the amplifier
first, then the power to this unit.

OPERATION

For details regarding operating part functions,
refer to PANEL FACILITIES on page 6.
1. Turn the POWER switch (2) ON.
• If the unit's power cord is connected to a
switched AC outlet on the amplifier or
receiver and the switch is left ON, the
unit can be turned ON/OFF together with
the amplifier or receiver.
• If the unit cannot be connected to the
amplifier or receiver, turn the power to
the amplifier or receiver ON before
turning the power to the unit ON. When
turning the power OFF, turn the power to
the unit OFF before turning the power to
the amplifier or receiver OFF.
2. Operate the amplifier or receiver and
adjust the volume of the other
speakers.
3. Adjust the volume of the bass with the
VOLUME knob (3).
• When necessary, operate the PHASE
switch (5) and then adjust with the
VOLUME knob (3).
4. Turn the POWER switch (2) OFF.
• The power indicator disappears.
CAUTION:
• Do not use the speaker to output distorted
sound for long periods of time. This can
result in damages to the speaker and poses
a potential fire hazard.

SPECIFICATIONS

Cabinet ............................... Bass-reflex, floor type
Speaker ....................................... 25 cm cone type
Power Amplifier Continuous Power Output
(RMS) ..................................... 160 W/6 Ω (100 Hz)
Input (sensitivity at 100 Hz)
LINE LEVEL (RCA jack)........................... 190 mV
Outline Dimension
............ 372 mm (W) x 394 mm (H) x 412 mm (D)
Weight (without package) .........................19.3 kg
Power Requirements
................................220 V to 240 V~, 50 Hz/60 Hz
Power Consumption ................................... 130 W
Power consumption in standby .........0.45 W less
Specifications and design subject to possible
modification without notice, due to
improvements.
Published by Pioneer Corporation.
Copyright © 2009 Pioneer Corporation.
All rights reserved.
7
En