Inhaltsverzeichnis
Werbung
USB-N66 WLAN Adapter User Manual
COFDM (for 802.11a or 802.11g)
Signal power alone is not enough to maintain 802.11b-like distances in an
802.11a/g environment. To compensate, a new physical-layer encoding
technology was designed that departs from the traditional direct-sequence
technology being deployed today. This technology is called C�FDM (coded
�FDM). C�FDM was developed specifically for indoor wireless use and offers
performance much superior to that of spread-spectrum solutions. C�FDM
works by breaking one high-speed data carrier into several lowerspeed
subcarriers, which are then transmitted in parallel. Each high-speed carrier is
20MHz wide and is broken up into 52 subchannels, each approximately 300KHz
wide. C�FDM uses 48 of these subchannels for data, while the remaining four
are used for error correction. C�FDM delivers higher data rates and a high
degree of multipath reflection recovery, thanks to its encoding scheme and
error correction.
Each subchannel in the C�FDM implementation is about 300KHz wide. At
the low end of the speed gradient, BPSK (binary phase shift keying) is used
to encode 125Kbps of data per channel, resulting in a 6,000Kbps, or 6Mbps,
data rate. Using quadrature phase shift keying, you can double the amount of
data encoded to 250Kbps per channel, yielding a 12Mbps data rate. And by
using 16-level quadrature amplitude modulation encoding 4bits per hertz,
you can achieve a data rate of 24Mbps. The 802.11a/g standard specifies
that all 802.11a/g-compliant products must support these basic data rates.
The standard also lets the vendor extend the modulation scheme beyond
24Mbps. Remember, the more bits per cycle (hertz) that are encoded, the more
susceptible the signal will be to interference and fading, and ultimately, the
shorter the range, unless power output is increased.
Default Key
This option allows you to select the default WEP key. This option allows you to
use WEP keys without having to remember or write them down. The WEP keys
generated using the Pass Phrase is compatible with other WLAN products. The
Pass Phrase option is not as secure as manual assignment.
Device Name
Also known as DHCP client ID or network name. Sometimes provided by an ISP
when using DHCP to assign addresses.
DHCP (Dynamic Host Configuration Protocol)
This protocol allows a computer (or many computers on your network) to be
automatically assigned a single IP address from a DHCP server.
21
ASUS WLAN adapter
Werbung
Inhaltsverzeichnis
