Safety Information For Drilling Machines - Parkside PSBM 500 B3 Betriebsanleitung

ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
Store idle power tools out of the
•
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
Maintain power tools. Check
•
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have
the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and
•
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
Use the power tool, accessories
•
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
• Carefully inspect the area to be cut
and remove all wires or other foreign
bodies.
Service
Have your power tool serviced
•
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety information for
drilling machines
• Wear ear protection during impact
drilling. The exposure to noise can
cause hearing loss.
• Use the additional handles delivered
with the device. The loss of control can
result in injuries.
• Hold the device by the insulated grip-
ping surfaces when performing work
in which the cutting tool may come into
contact with hidden wiring or its own
cord. Contact with a live wire can also
cause a charge in metal parts of the
device and result in an electric shock.
• Use suitable detectors in order to find
hidden supply lines or ask the local
utility company. Contact with electrical
cables can lead to electric shock and
fire, contact with a gas pipe can result
in an explosion. Damage to a water
pipe can lead to property damaged
and electric shock.
• Keep hands away from rotating parts.
Wait until the power tool has stopped
before placing it down. Risk of injury!
• Avoid contact with the tool insert or
the component part immediately after
processing. The parts may be hot and
cause burn injuries.
• Immediately switch off the power tool
if the tool insert is blocked due to
overloading or tilting of the component
part. The loss of control can result in
injuries.
• Secure moving component part with
clamping devices. A hand held tool
can slip and endanger your safety.
GB IE CY
9