Werbung
Required in Appendix ZB of BS 7002 (En 60 950) – United Kingdom
The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable
(moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse to
BS1362 marked
or
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without the
fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied
either cut-off the moulded plug (If this type is fitted) or remove by undoing the screws if a rewireable
plug is fitted and fit an appropriate type observing the wiring code below.
DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately and
disposed of in a safe manner. Under no circumstances shold the cut-off plug be inserted elsewhere into
a 13A socket outlet as a serious electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
GREEN-AND-YELLOW: Earth
BLUE: Neutral
BROWN:
As the colours of the wires in this mains lead may not correspond with coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug
which is marked with the letter E, or by the safety earth symbol
yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N
or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter
L or coloured red.
If you have any doubt, consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED:
AR-150 series_Front.p65
MAINS PLUG WIRING INSTRUCTIONS
and of the same rating as the one removed from the plus must be used.
Live
19
, or coloured green or green-and-
20/09/99, 09:58
Werbung
Kapitel
