Technical Data; Before Starting The Equipment - EINHELL TC-BJ 900 Originalbetriebsanleitung

4. Technical data

Voltage: ......................................... 230 V ~ 50 Hz
Power rating: ........................................ 860 watts
Idling speed: ...................................... 11,000 rpm
Cutter dimensions: .............ø 100 x ø 22 x 3,8 mm
Cutting depth: ................................... max. 14 mm
Angle settings: .......................................... 0°-90°
Protection class: ............................................ II/
Weight: .......................................................3.0 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 88 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 99 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
Additional handle
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Anl_TC_BJ_900_SPK1.indb 16 Anl_TC_BJ_900_SPK1.indb 16
= 5.252 m/s
2
h
2
≤ 2.5 m/s
2
h
2
- 16 -
GB
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the dust extractor adapter (Fig. 2)
The adapter for the dust extraction system (5) and
the dust bag (6) must be fi tted (Fig. 2).
5.2 Setting the cutting depth (Fig. 3)
•
Set the required cutting depth with the setting
wheel (3).
•
The designations on the setting wheel reflect
the various sizes of biscuit dowels
•
Push the drive motor (11) forwards to check
the cutting depth. The plug must be discon-
nected from the mains supply for this purpo-
se.
•
You can adjust the cutting depth setting using
the screw (a).
19.01.15 13:03 19.01.15 13:03