Proosten Electronics ProMax 212-15 Gebrauchsanweisung Seite 25

English
Error 6
Charger doesn't work.
The Power LED lights,
but the charger doesn't
work
The charger gives the
correct indication but the
battery is not charging.
The charger does not
supply the correct voltage
(and current).
Charger doesn't deliver
its maximum charging
current
When the Promax 200 still is not functioning well after the actions stipulated, you can
consult your supplier. The charger must be sent prepaid. The only activities that may carried
out is the replacement of the input fuse.
25
Temperature sensor broken.
The charger is set for use of the
temperature sensor, but the
sensor isn't present.
No mains voltage.
Mains voltage to low.
The charger is busy with a soft
start.
Mains voltage to low.
Repleace the temperature
sensor.
Change the charging program
(page 18).
- Measure the mains voltage. It
should be higher then 180VAC
(95VAC for 115VAC input).
- Have the internal fuse
checked by your dealer.
Measure the mains voltage. It
should be higher then 180VAC
(95VAC for 115VAC input).
3 minutes after switching on the
charger, the correct charge
level is indicated.
Measure the mains voltage.
Below a voltage of 200VAC
(100VAC for 115VAC input)
the charger can't deliver its
complete charging current.