Introduction; Intended Use; Features; Delivery Contents - Parkside PSS 250 A1 Betriebsanleitung

Introduction

Orbital sander PSS 250 A1
Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.

Intended use

The oscillating sander is suited for dry sanding of
wood, plastics and paints. Any other use or modifi-
cation is considered improper use and involves sig-
nificant accident risks. The manufacturer declines to
accept responsibility for damage(s) arising out of
usage contrary to the instructions specified below.
The appliance is not meant for commercial use.

Features

ON / OFF switch
1
Locking button for the ON / OFF switch
2
Release button
3
Dust collection box
4
Connection (vacuum dust extraction)
5
Clamping bars
6
Tensioning lever
7
Sanding plate
8
Sanding sheet
9
Oscillation speed selection
10
Grip surface
11
Reducer
12

Delivery contents

1 Orbital sander PSS 250 A1
1 Sanding sheet (Grit 120), see Fig. F
16 GB
1 Dust collection box
1 Reducer, see Fig. D
1 Operating manual

Technical Data

Nominal voltage:
Nominal power:
Non-load speed:
Non-load oscillation speed: n
Sanding sheet dimensions: Hook and loop fasten-
Protection class:
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 60745. The A-weighted noise
level of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1.5 m / s
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
230 V∼, 50 Hz
250 W
n 7000–12000 rpm
0
14000–24000 rpm
0
ing 92 x 182 mm
Clamp fastening
92 x 230 mm
II /
79 dB(A)
90 dB(A)
3 dB
= 10.2 m / s
2
2