Using The Accessories; Cleaning And Care; Information About Warranty And Service Processing - Parkside PABK 60 A1 Betriebsanleitung

... / Cleaning and care / Information about warranty and service processing
Using the accessories (see Ill. D)
Air mattress adapter
Use a pipe wrench to unscrew the nozzle
of the blow-out gun
Then – depending on what is needed – screw
on the air mattress adapter
dle , as well as the thread adapter
12
the barrel of the air blow gun
Universal valve connection
Screw the universal valve adapter (suitable for
tyres, e.g. bicycle tyres)
hose .
8

Cleaning and care

Thoroughly clean the spray stylus
ately after use. Otherwise the paint can dry and
cause problems during the next use.
Thoroughly rinse out the spray stylus
water.
Use the thinner included to clean any stubborn
dried paint.
Note: The thinner is not suitable for water-so-
luble paints. Rather, it corresponds to a varnish
for thinning paints containing solvents.
Note: If the air intake of the compressor should
become dirty, use a dry cloth to remove the ac-
cumulated dirt.
Fault
Cause
1. Paint almost
empty
2. Paint too viscous 2. Lower viscosity
3. Dry / defective
nozzle
4. Paint supply
restricted
96759_par_Airbrush_Set_Content_DE_AT_NL.indd 31
, Ball needle
6 12
9a
.
9
or the ball nee-
6
into
7
.
9
10
directly onto the air
10
immedi-
3
with
3
Interrupted paint jet
or intermittent paint
delivery
Solution
1. Fill paint
3. Screw in nozzle tightly
or replace
4. Cleaning
Fault Interrupted paint jet
or intermittent paint
delivery
Cause Solution
5. Incorrect posi- 5. Correct position angle
tion of spray
stylus .
3
Fault Spray pattern
incomplete
Cause Solution
1. Air head 1. Clean / replace air head
dirty / defective
1. Rinse with clear water
2. Nozzle dirty / 2. Clean / replace air
defective nozzle
Fault Spray pattern irregu-
lar with drips
Cause Solution
1. Defective nozzle 1. Replace nozzle. Contact
a respective service centre.
2. Paint too viscous 2. Lower viscosity
3. Insufficient 3. Increase working pres-
working pres- sure (if necessary, not in-
sure cluded accessories, e.g.
pressure reducer)
3. Hose defective; replace
hose
Fault Non-uniform paint
amount delivered
Cause Solution
Nozzle dirty / Clean / replace air nozzle
defective
Information about warranty
and service processing
Creative Marketing Consulting GmbH
warranty
Dear customer, the warranty for this device is 3 years
from the date of purchase. In the event the product
GB 31
28.04.14 09:11