Rotating The Hand Grip; Adjusting The Shoe; Setting The Blade Speed; Preparing For Use - Parkside PFS 710 B1 Betriebsanleitung

Before use / Preparing for use

Rotating the hand grip

Q
DANGER OF INJURy! Pull
the mains plug out of the socket before you carry
out any task on the device. The hand grip
be rotated by 90° to the right or left. This allows
the On / OFF switch
3
comfortable position for any working conditions.
P ress the unlocking button
hand grip to the right or left.
4
M ake sure the hand grip

Adjusting the shoe

Q
DANGER OF INJURy! Pull
the mains plug out of the socket before you carry
out any task on the device.
A djust the shoe
5
T o do this release the shoe adjustment lever
and place the shoe
L ock the shoe in this position by pulling the
shoe adjustment lever

Setting the blade speed

Q
With the oscillation speed setting wheel
chose the desired stroke rate (- = lower stroke rate,
+ = higher stroke rate).
The stroke setting can also be changed during op-
eration.

Preparing for use

Q

Switching on and off

Q
When operating the device you can select between
intermittent or continuous operation mode.
To switch on intermittent operation mode:
P ress the On / OFF switch
30 GB
can
4
to be brought into the most
and rotate the
10
engages.
4
to suit the cutting depth.
in appropriate position.
5
tight.
8
you can
1
.
3
To switch off intermittent operation mode:
R elease the On / OFF switch
To switch on continuous operation mode:
P ress the On / OFF switch
pressed position with the lock button
To switch off continuous operation mode:
P ress the On / OFF switch
again.
Guiding the sabre saw
Q
safely and accurately
The shoe pivots to adjust to the workpiece and
5
provides safe support to the device. It must always
lie against the workpiece when the device is in use.
8
Advice about ways of
Q
working when sawing
B efore sawing, check the workpiece for foreign
bodies such as nails, screws etc. and remove them.
D o not allow the ventilation slots to become
covered.
S witch the device on first and only then bring it
into contact with the workpiece.
I f the saw blade jams, switch off the device im-
mediately.
Open the sawn gap in the workpiece slightly
using a suitable tool and extract the saw blade.
A lways make sure the saw blade type and the
blade oscillation speed are suitable for the
workpiece material.
T here are different saw blades available in var-
ious lengths designed to ensure optimum perfor-
mance of every sawing task with your sabre saw.
S aw the material using a steady forward rate
of progress.
Flush sawing:
Using flexible saw blades of adequate length you
can trim off projecting workpieces, such as pipes,
directly at the face of a wall.
.
3
and fix it in the
3
.
2
and release it
3