Installing Sanding Belts; Setting The Working Depth; Milling Direction For Edges; Plunge Cutting - Parkside PSFS 250 A1 Betriebsanleitung

Operation
Note: Please use suitable accessories available
from your speciality retailer to cut wall tiles and /
or edit sheets of metal / light metal.

Installing sanding belts

Install the sanding belts

Setting the working depth

(see Fig. E)
Loosen the wing bolt
Slide the base plate
depth (to cut through completely set approx.
3.2 mm deeper than the material thickness).
The recommended maximum cutting depth for
wood is 13 mm *(only applies to multipurpose
cutter (HSS) ).
18
Retighten the wing bolt

Milling direction for edges

Plunge cutting

Insert the bit into the work piece at an angle
of 45°.
Slowly straighten the bit to an angle of 90° to
begin the cut.
Note: The base plate
material surface.
30 GB
as shown in Figure C.
16
.
5
to the desired working
7
.
5
must be flush with the
7
Pivot handle (see Fig. F)
Note: Turning the grip during the start up opera-
tions is forbidden. Remove the plug from the socket
and make sure that the swivel lock
Pivot to horizontal
Press and hold the bevel stop
Turn the handle counter-clockwise
tical to horizontal until the bevel stop locks in.
Pivot to vertical
Press and hold the bevel stop
Turn the handle clockwise
to vertical until the bevel stop locks in.
Using the rip fence (see Fig. G)
Loosen the wing bolts
and slide the guide bar for the circle- / rip
fence through the two openings in the bot-
15
tom of the base plate
facing down.
Position the tool the desired distance from the
edge of the work piece. Tighten the wing bolts
to secure the circle- / ripe fence
plate .
7
Cutting circles (see Fig. H)
Note: The position of the guide hole depends on the
desired result, either inside or outside of the edge
of the circle: inside for holes, outside for discs. The
radius can be set from ca. 5 to 16 cm.
7
is engaged.
13
.
13
from ver-
.
13
from horizontal
on the base plate
9 7
, with the rip fence
7
9
to the foot
15