Switching Off; Setting The Cutting Depth; Changing The Engraving Point - Parkside PGG 15 B1 Betriebsanleitung

Switching off:

Release the ON / OFF switch

Setting the cutting depth

The cutting depth of the engraver is set using the stroke rate rotary control-
ler . A low setting is usually sufficient for most common applications.
2
Turn the stroke rate rotary controller
crease the cutting depth.
Turn the stroke rate rotary controller
crease the cutting depth.
Note: Take care when increasing the cutting depth not to turn the stroke
rate rotary controller
could screw off the device.

Changing the engraving point

performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
and no longer provides the desired engraving performance. Turn
the engraving point holder
point is released.
5
Remove the spring and the plain washer.
1
too far towards the + sign. Otherwise the switch
2
RISK OF INJURY! Switch the device off before
5
anticlockwise until the engraving
6
.
towards the + sign to in-
2
towards the
2
as soon as it becomes too worn
Operation
-
sign to de-
GB 45