Gear Drive; Operation; Switching On / Off; Setting The Speed - Parkside PABS 14.4 A1 Betriebsanleitung

F or drilling, push the selector to the setting for
drilling, in that you adjust the torque pre-selector
to the position .

2 Gear Drive

CAUTION! Move the gear selector switch
only after the device has come to a standstill.
Failure to observe this advice may result in damage
to the device.
In the first gear (Gear selector switch
in Position: 1)
A speed of up to approx. 400 rpm can be achieved
and a high torque. This setting is intended for use with
all screwing tasks and for accessories (see example
Fig. B).
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks (see example Fig. A).

Operation

Switching ON / OFF

Switching on:
T o start the appliance squeeze on the ON /
OFF switch and then keep it pressed down.
3
The LED working light
or fully pressed ON /OFF switch
nates the working area in poor lighting conditions.
Switching off:
T o stop the appliance, release the ON / OFF
switch .
3

Setting the speed

The ON / OFF switch
3
trol device. Slight pressure on the ON / OFF switch
will cause the rotation speed to slow down. With
3
increased pressure, the rotational speed will increase.
1
comes on with a slightly
8
and illumi-
3
has a variable speed con-
Note: The integrated engine brake means that the
device will come to a fast standstill.

Switching direction of rotation

T o switch the direction of rotation, push the
direction of rotation switch
1
right or to the left.

Tips and Tricks

B efore you use the appliance, check to see
that the screw or drill bit is properly fitted, i.e.
located centrally in the chuck.
S crew bits are designated with their dimensions
and their shape. If you are unsure, always try
the particular screw bit out to see whether it sits
in the screw head without any free play.
1
Torque:
S maller screws and bits in particular can be
easily damaged if you adjust the appliance
with too high a torque and / or rotation speed.
Hard screwdriving conditions (into metal):
P articularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
Soft screwdriving conditions (e.g. into
soft wood):
Y ou should also select a low speed in order not to
damage the wood workpiece surface through con-
tact with the metal screw head. Use a countersinker.
When drilling into wood, metal and other
materials, take note of the following advice:
W ith small diameter drill bits use a high drill
speed. For large diameter drill bits, use a low
drill speed.
F or hard materials, select a low drill speed.
For soft materials, select a high drill speed.
S ecure or fix down the workpiece (if possible)
in a clamp or vice.
Start-up / Operation
to either the
2
GB 31