Switch Led On / Off; Adjusting The Handle; Torque Setting; Battery Level Display - Parkside PASS 3.6 B2 Betriebsanleitung

Anti-clockwise:
GB
IE
♦ Push the rotation direction switch
CY
♦ Press the ON/OFF switch
unscrew the screws.
Safety lock-out:
♦ Push the rotation direction switch
middle position. The ON/OFF switch
blocked.
Switch LED
Switching on:
♦ Press the ON/OFF switch
pressed in.
Switching off :
♦ Release the ON/OFF switch

Adjusting the handle

The screwdriver can be locked into two diff erent
handle settings To do this, press the locking button
and set the screwdriver into the desired position.
Afterwards, release the locking button

Torque setting

The torque for a specifi c screw size can be set using
the torque setting
ent on an number of factors:
- the type and hardness of the material being
worked.
- the type and length of the screws being used.
- the demands being put on the screw joint.
When the set torque is reached, this is indicated
by the actuation of the clutch.
6
to the right.
. You can now
into the
on / off
and keep it
.
.
. The required torque is depend-

Battery level display

The battery level display
level using 3 coloured LEDs.
All LEDs are lit up:
The battery is fully charged.
Red and yellow LEDs lit:
is
The battery has a suffi cient remaining charge.
Red LED:
The battery is fl at. Recharge it.

Tips and tricks

Screw bits are labelled according to their dimen-
sions and their shape. If you are unsure, always try
the particular screw bit out to see whether it sits in
the screw head without any free play.

Maintenance and cleaning

RISK OF ELECTRIC SHOCK! Before
cleaning, disconnect the charger
the mains socket.
The cordless screwdriver is maintenance-free.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Never allow fl uids to get into the appliance.
■ Use a soft cloth to clean the appliance housing.
Never use benzine, solvents or cleansers which
can damage plastic.
indicates the charge
from
PASS 3.6 B2