Herunterladen Diese Seite drucken

Trouble Shooting - Parkside PAS 500 D3 Betriebsanleitung

Vorschau ausblenden

Werbung

Inhaltsverzeichnis
GB

Trouble shooting

Problem
Device does not start
Low or lack of suction
24
Possible cause
Mains voltage is not present
The equipment is not
switched on
Safety stop due to miss-
ing or incorrectly inserted
pleated filter (
 13)
Defective on/off switch
(
6)
Defective motor
The single-use thermal fuse
has disconnected the power
circuit
Suction hose (
 11) or suc-
tion tube (
 12) blocked
The metal container (
is not closed
The metal container (
is full
The pleated filter (
clogged
The air filter (
18) is
clogged
Pre-filter (
 15) is clogged
Pre-filter (
 15) reduces
the suction power
Fault correction
Check plug socket, power cord,
line, plug and fuse, where ap-
propriate, repair through electri-
cal specialist
Switch on the equipment (see
"switching on/off")
Insert the pleated filter correctly
(see "cleaning/maintenance")
Repair through customer service
Remove obstructions and block-
ages
 10)
Close the metal container
 10)
Empty the metal container (see
"cleaning/maintenance")
Clean or replace the pleated
 13) is
filter (see "cleaning/mainte-
nance")
Clean the air filter (see "clean-
ing/maintenance")
Clean or replace pre-filter (see
"Cleaning/Maintenance")
To vacuum coarse dirt, remove
the pre-filter

Werbung

Kapitel

Inhaltsverzeichnis
loading

  Andere Handbücher für Parkside PAS 500 D3

  Verwandte Anleitungen für Parkside PAS 500 D3

  Verwandte Inhalte für Parkside PAS 500 D3

Diese Anleitung auch für:

Pas 500 d2Ian 90977