Using The Router Tool; Attaching The Extractor Adapter; Reducer; Changing The Collet - Parkside POF 1200 A1 Bedienungsanleitung

Start-up / Operation

Using the router tool

Press and hold the spindle lock key
Release the union nut
spanner by turning it anticlockwise.
27
Release the spindle-lock key
Then use the router tool. This must be inserted
at least 20 mm (shaft length).
Tighten the union nut
ended spanner
27

Attaching the extractor adapter

Put the extractor adapter
tractor provided.
18
Screw together the extractor's screws
the under side of the base plate
Connect a vacuum device approved for the
extraction of sawdust and splinters to the ex-
tractor (see Fig. G).
21

Reducer

Connecting:
Slide the reducer
28
Slide the hose for an approved dust extraction
unit (e.g. a workshop vacuum) onto the reduc-
er .
28
Removal:
Pull the hose of the vacuum unit off of the re-
ducer .
28
Pull off the reducer

Changing the collet

Note: All router bits of the router sets have a 8 mm
shaft.
Start with the already installed collet 8 mm
Change the collet for a router bit with a 6 mm shaft
as described below.
Release the union nut by turning it anticlockwise
using the open-ended spanner
8 mm is removed.
4
Insert the collet 6 mm
10 GB/CY
.
10
with the open-ended
3
.
10
firmly with the open-
3
.
on the drilling ex-
21
and
22
.
7
in to the suction adapter
.
28
.
4
until the collet
27
.
23
ATTENTION! Tighten the union nut
with the open-ended spanner
er bit is inserted. Otherwise the collet might
17
be damaged.

Fitting the guide fence

Unscrew the both of the sliding bar's
screws with a Philips screw driver.
Secure the sliding bar
tighten the screws.

Operation

Switching on and off

Switching on:
Press and hold the start lockout
Activate the ON / OFF switch
machine has started, release the start lockout
Switching off:
Release the ON / OFF switch
.
21

Presetting the speed

Set the desired speed using the speed setting
wheel .
1
1–2 = low speed
3–4 = middle speed
5–7 = high speed

Set the milling depth

1. Ensure that the clamping lever
If it is loose turn it anti-clockwise until it is locked.
2. Place the device on the work piece to be worked
upon.
3. Turn the step stop
position.
4. Loosen the lock screw
firmly
3
once the rout-
27
29
to the rip fence
29 24
.
20
. Once the
19
.
19
is locked down.
16
until it locks into the lowest
9
.
11
and
.
20