Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety; Electrical Safety - Parkside PSS 250 A1 Bedienungsanleitung

Technical Data

Nominal voltage:
Nominal power:
Non-load speed:
Non-load oscillation speed: n
Sanding sheet dimensions: Hook and loop fasten-
Protection class:
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 60745. The A-weighted noise
level of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1.5 m / s
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actu-
ally in use. This can result in a much lower vibration
load over the whole of the period of working.
Introduction / General safety advice for electrical power tools
230 V∼, 50 Hz
250 W
n 7000–12000 rpm
0
14000–24000 rpm
0
ing 92 x 182 mm
Clamp fastening
92 x 230 mm
II /
79 dB(A)
90 dB(A)
3 dB
= 10.2 m / s
2
2
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electric-
ity (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a mains
lead).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there are-
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.

2. Electrical safety

a) The mains plug on the device must
match the mains socket. The plug must
not be modified in any way. Do not use
an adapter plug with devices fitted with
a protective earth. Unmodified plugs and
matching sockets reduce the risk of electric shock.
b) Avoid touching earthed surfaces such
as pipes, radiators, ovens and refrig-
erators with any part of your body.
GB/IE 7