Uni-Hockey / Floorball - Stramatel Multisport Serie 452 Bedienungsanleitung

UNI-HOCKEY / FLOORBALL

Set-up
Connect all the control consoles to each other (the control consoles can be connected in any order). The
"Individual fouls/points" control console is only supplied with scoreboards equipped with individual fouls
modules.
Press the ON/OFF key until the console displays the welcome screen.
Programming
Select the "Unihockey / Floorball" mode with key 12.
The console screen displays the stored configuration during a few seconds: length of the pre-match
period, number and length of game periods, mode of display of the game timer (count-up or count-
down), length of the extra-time periods, length of the time-outs, number of time-outs (1 per match or 1
per period), length of the rest periods between the game periods.
Press key 18 to view the data on the console screen longer.
Change the configuration with key 0 or play with the stored configuration with key 9.
To change configuration: answer the various questions displayed on the console screen with keys 0 to 9,
and enter your answer with key 23.
During programming, it is always possible to come back to the previous programming with key 13.
Pre-match timer / Game timer
Some of the timer features can also be controlled by the separate timer control console (See. "Functions
of the separate timer control console" – Page 5).
Start or stop the pre-match timer with key 18.
If needed, stop the pre-match timer to charge the 1
Start or stop the game timer with key 18.
Game timer in count-down mode: display on the console screen the elapsed game time instead of the
remaining time and vice versa with key 21.
End of the first game periods: the rest timer starts automatically in count-up mode.
If the game timer was not stopped quick enough at the end of the period: come back to the game timer
by pressing keys 16 and 18 simultaneously.
End of the rest period: the next game period is loaded automatically.
Start the game timer with key 18.
End of the last game period and end of each extra-time period: the rest timer does not start
automatically. If needed, press key 18.
This rest period is not limited to the programmed time: stop the rest timer and load a new game period
or an extra-time period with key 28.
Correction of the game timer:

stop the game timer with key 18, then enter in timer correction mode by pressing keys 16 and
18 simultaneously.

shorten the game time with key 16 or increase it with key 20. Enter with key 18.
ZI de Bel Air 44850 LE CELLIER FRANCE
UA452MXX0XX_A - Control console 452M.docx
st
game period with key 28.
stramatel@stramatel.com Tél. +33 (0)2 40 25 46 90
Page 28