Power Cord - Pioneer AVH-X2700BT Installationsanleitung

Connection
This product
1
3
2
4
1 Pioneer navigation system
Please contact your dealer to 4 m inquire about the connect-
able navigation unit.
2 RGB cable(Supplied with Navigation system)
3 Microphone 4 m
4 This product
5 Wired remote input
Hard-wired remote control adapter can be connected (sold
separately).
6 Digital Radio antenna input
(AVH-X5700DAB) (AVH-X3700DAB)
7 Antenna jack
8 Power supply
9 Fuse (10 A)

Power cord

2
2*
5 4*
6
7
8
9 8 7
9
g
1.
l
1
1*
3*
3 4
5 6
c
a (5*) b (6*)
d
e
f
2.
i
h
j
k
1 To power supply
2 Depending on the kind of vehicle, the function of 2* and 4*
may be different. In this case, be sure to connect 1* to 4*
and 3* to 2*.
3 Yellow (2*)
Back-up (or accessory)
4 Yellow (1*)
Connect to the constant 12 V supply terminal.
5 Red (4*)
Accessory (or back-up)
6 Red (3*)
Connect to terminal controlled by ignition switch (12 V DC).
7 Connect leads of the same color to each other.
8 Orange/white
To lighting switch terminal.
9 Black (ground)
To vehicle (metal) body.
a Blue/white (5*)
The pin position of the ISO connector will differ depending
on the type of vehicle. Connect 5* and 6* when Pin 5 is an
antenna control type. In another type of vehicle, never con-
nect 5* and 6*.
b Blue/white (6*)
Connect to auto-antenna relay control terminal (max. 300
mA 12 V DC).
c Blue/white
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
d Violet/white
Of the two lead wires connected to the back lamp, connect
the one in which the voltage changes when the gear shift
is in the REVERSE (R) position. This connection enables
the unit to sense whether the car is moving forwards or
backwards.
e Yellow/black
If you use an equipment with Mute function, wire this lead
to the Audio Mute lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
f Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the
parking brake switch.
g Connection method
1 Clamp the lead.
2 Clamp firmly with needle-nosed pliers.
h Power supply side
i Parking brake switch
j Ground side
k Speaker leads
White: Front left + or high range left +
White/black: Front left – or high range left –
3