Installation With The Holder; Installing The Microphone; Mounting On The Sun Visor - Pioneer AVH-X2800BT Installationsanleitung

Installation
3 Pull the unit out of the holder.
1
1 Extraction key

Installation with the holder

1 Install the holder into the dashboard.
2 Secure the mounting sleeve by using a screw-
driver to bend the metal tabs (90°) into place.
1
2
1 Dashboard
2 Holder
3 Install this product into the holder.
1
1 Dashboard
4 Attach the trim ring.
1 2
1 Trim ring
2 Groove
Attach the trim ring with the side with a groove facing
downward.
Installation using the screw
holes on the side of this
product
1 Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes are aligned with
the screw holes of the bracket, and tighten the screws at three
locations on each side.
Use either the truss head screws (5 mm × 8 mm) or flush
surface screws (5 mm × 9 mm), depending on the shape of the
bracket's screw holes.
1
4
3
1 Factory radio-mounting bracket
2 If the pawl interferes with installation, you may bend it down
out of the way.
3 Dashboard or console
4 Truss head screw or flush surface screw
Be sure to use the screws supplied with this product.

Installing the microphone

 Install the microphone in a place where its direction and dis-
tance from the driver make it easiest to pick up the driver's
voice.
 Be sure to turn off (ACC OFF) the product before connecting
the microphone.

Mounting on the sun visor

1 Fit the microphone lead into the groove.
1 Microphone lead
2 Groove
2 Attach the microphone clip to the sun visor.
2
1
2
7