Initial Auto Installation; Checking Signal Strength And Channel Strength - Pioneer KRL-32V Bedienungsanleitung

Quick guide

Initial auto installation

When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Confirm the following before turning
on the power
E
Is the antenna cable connected?
E
Is the AC cord plugged in?
1
Press a on the TV.
• The initial auto installation wizard appears.
2
Setting the OSD language.
English
Italiano
Svenska
Press a/b/c/d to select the desired language,
and then press ENTER.
3
Setting the country (Location of the TV).
Austria A B/G
Finland FIN B/G
Greece GR B/G
Press a/b/c/d to select your country or area,
and then press ENTER.
• This setting screen only appears during the first
installation.
4
Starting channel search.
Digital Search
Press c/d to select "Digital Search" or
"Analogue Search", and then press ENTER.
• If you want to search for more broadcasts, execute
"Additional Search" from the "Programme Setup"
menu (Pages 32 and 33).
• To watch both analogue broadcasts and digital
broadcasts, you should perform the channel search
setting for each format.
EXAMPLE
• If you execute "Digital Search" in the initial auto
installation wizard, you should perform "Analogue
Search" from "Auto Installation" under the "Setup"
menu.
Analogue Search
5
The TV searches for, sorts and stores all the
receivable TV stations according to their settings
and the connected antenna.
• To abort the initial auto installation in progress, press
6 (RETURN).
NOTE
• If you turn off the power on the TV after performing step 4,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the "Setup" menu (Page 32).
• The initial auto installation wizard will go off if you leave
the TV unattended for 30 minutes before searching for
channels in step 5.
Checking signal strength and
channel strength
If you install a DVB-T antenna for the first time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
1
Press h and the "HOME MENU" screen
displays.
2
Press a/b to select "Setup".
3
Press a/b to select "Antenna Setup-DIGITAL",
and then press ENTER.
E
Checking signal strength
Press a/b to select "Signal Strength".
Supply Voltage
Signal Strength
Channel Strength
CH No.
Signal Strength
Quality
E
Checking channel strength
Press a/b to select "Channel Strength", and
then press ENTER.
• You can input a specified frequency band using the
0–9 numeric buttons.
Supply Voltage
Signal Strength
Channel Strength
CH No.
Signal Strength
Quality
4
Position and align the antenna so that the
maximum possible values for "Signal Strength"
and "Quality" are obtained.
NOTE
• The values of "Signal Strength" and "Quality" indicate when
to check the appropriate alignment of the antenna.
21
Current 0 Max. 0
Current 0 Max. 0
4 7 4 . 0
MHz
21
Current 0 Max. 0
Current 0 Max. 0
15