Preparation; Supplied Accessories; Attaching The Stand Unit - Pioneer KRL-32V Bedienungsanleitung

Preparation

Supplied accessories

Remote control unit
(g1)
TV
INPUT
1 2 3 4
5 6 7 8
TV DTV RADIO
1 2 3
4 5 6
7 8 9
INFO
0
P.INFO
CH RETURN
P
DVD TOPMENU/
EXIT GUIDE
EPG
ENTER
HOME
MENU RETURN
MENU
HDMI REC STOP
CTRL
SCREEN AV
CM SKIP SIZE SELECTION
TOOLS DVD HDD
SOURCE SELECT
TV DVD
STB DVR VCR
Pages 3 and 11
• Operation manual (This publication)
• Warranty card

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1
Confirm that there are ten screws with the stand
unit.
2
Attach the supporting post for the stand unit
onto the base using the six screws with the
screw driver (supplied) as shown.
Supporting
post
10
AC cord (g2)
Page 14
• "AA" size alkaline battery (g2) ... Page 11
3
NOTE
• To detach the stand unit, perform the steps in reverse
order.
Cable clamp (g1)
Page 14
Inserting the stand.
1
Insert the stand into the openings on the
bottom of the TV (Hold the stand so it will
not drop from the edge of the base area).
2
Insert and tighten the four short screws into
the four holes on the rear of the TV.
2
Stand unit (g1)
Page 10
Soft
cushion
1