Operation; Food Storage; Maintenance - Kalorik Exc Rfg 1 Handbuch

Fax +32 2 359 95 50

OPERATION

1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth and the interior
with a clean moist cloth.
2. Insert the plug into a power socket.
3. Turn the thermostat dial to "5" or "low". Close the door and let the refrigerator operate for
15 to 20 minutes.
4. When the refrigerator works with full power, the two LED's on the circuit board will flash.
The red one shows the power input status. The green one shows the output status of the
cooling system. Meanwhile the fan inside the refrigerator begins to work. When the door is
opened, the light under the temperature adjustor will turn on automatically.
5. To control the internal temperature, adjust the thermostat. Position "high" is the warmest,
setting "low" is the coldest. The temperature range for the refrigerator is between 5-15°C.
When the temperature is set on a certain point and the temperature inside reaches this
point, the automatic temperature control system begins to work and the cooling system
goes into linear temperature keeping status.
Note: if you have unplugged the refrigerator, wait 3-5 minutes before restarting it. The unit may
fail to operate properly if restarted too quickly.
COOLING SPEED
The temperature inside can be cooled to 5°C within 2 hours (if the unit is empty). When the
temperature control is adjusted, the temperature will be balanced again in a certain period,
depending on how big the change in temperature is and on the ambient temperature.

FOOD STORAGE

1 to 2 hours after plugging in the appliance, the refrigerator is adequately cooled and food
can be stored. The refrigerating temperature of the thermoelectric cooler is 5-15°C.

MAINTENANCE

•
Unplug the appliance before cleaning.
•
Never use any harsh, abrasive cleaners, heavy-duty cleaners or solvents on any surface.
•
Wipe the exterior with a damp, sudsy cloth, then rinse and dry. For stubborn stains and for
periodic waxing, use silicon wax.
•
Wash the shelves and other removable parts in warm sudsy water, rinse and dry. Wash the
interior with baking soda solution (3 tablespoons to 1 litre of water) or warm sudsy water,
rinse and dry.
•
Wash the magnetic door seals with warm sudsy water.
•
Never immerse the appliance in water or any other liquid.
•
Replace all parts, insert the plug into a power socket and turn the thermostat dial to the
desired setting.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
14
Assembly page 14/40
EXC RFG 1 - 110310