Switching Input Modes - Yamaha DVX-S120 Bedienungsanleitung

Switching Input Modes

DVR-S120 WB56650
POWER
AUDIO
SELECT MATRIX 6.1
/DTS
NIGHT
SW
TV INPUT
TV CH
A B C D E
PRESET
ON SCREEN
CH
ENTER
STATUS
TV VOL
MUTE
AMP
DVD/CD
VCR
TUNER
MOVIE MUSIC
CINEMA
Advice
• It is possible to switch Input mode even if you press INPUT on CinemaStation for more than one second.
• When Input mode is set to AUTO and a Dolby Digital or DTS signal is input, the most suitable decoder is automatically
selected.
• The following happens when set to Input mode and DTS is played:
— CinemaStation detects the DTS signal and automatically switch to DTS mode (t indicator lights up). Once DTS audio
finishes playback, the t indicator may blink, and while it blinks only DTS audio can be played back. Immediately after
DTS audio finishes playback, if you want to play normal PCM audio, reset the Input mode to AUTO.
— If the DTS signal is interrupted when you perform Search or Skip, the t indicator may blink. If this condition continues
for over 30 seconds, the Input mode automatically changes from DTS to normal digital (PCM) and the t goes out.
• Using "* Input Mode" in the SET MENU you can set whether to use the Input mode specified previously when CinemaStation
was turned on or return to AUTO.
Note
• It is not possible to select ANLG with the DVD/CD Input Selection button.
• You cannot switch input modes when the input jack you select with the Input Selection button can only input an analog input
signal.
• To play back DTS, set the Input mode to AUTO or DTS. Do not set it to ANLG. If you do, audio may not output or you may
hear noise.
You can playback most sources without a problem with
the AUTO setting (factory default setting). Then depending
on your needs, you can select the priority level for digital
and analog input signals, and specify formats such as
DTS.
POWER
TV
ANGLE SUBTITLE
STEREO
REPEAT A-B
CENTER SURR
SHIFT
AUTO:
SLEEP
PRESET
DTS:
ANLG:
MENU
SET MENU
Learning about input modes, jacks and Input Selection
CH
buttons
RETURN
CinemaStation can receive signals from the VIDEO (analog),
TEST
VOLUME
VCR (analog) and OPTICAL (digital) jacks of equipment that
is connected to it. You can assign a VIDEO or VCR input name
to the OPTICAL IN jack. This will allow you to use the VIDEO
button or VCR button to input a device connected to the
VIDEO
Input
OPTICAL IN jack (VIDEO is assigned in the default setting.)
Selection
Normally, an analog signal is input to the VIDEO or VCR IN
buttons
SPORTS GAME
jack, and a digital signal is input to the OPTICAL IN jack.
However, by setting the input mode to AUTO the input will be
automatically detected and you can then playback audio from
the device you want by simply pressing an Input Selection
button.
Press the Input Selection button for current input
source until the desired input mode appears in the
CinemaStation Display.
Input signal can be selected in the order below.
1) Digital signal
2) Analog signal
Only DTS can be played.
Only analog signal can be played.
Types of Input Signals
77