Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Creating the Best Listening Space
Placing the Front and Surround Speakers
When placing on the floor or a rack
When attaching to a wall
Screws (3.5 to 4 mm (
dia., commercially available)
70 mm (2
3
/
)
70 mm (2
4
25
20 mm (
/
)
32
or more
Note
• One speaker weighs about 1.1 kg (2.43 lb). Make sure you fasten screws only into a solid wall or pillar. Do not attach to a wall
that is made of plaster, decorative veneer sheeting or other material that peels easily. If the screws come off and a speaker falls,
somebody may get injured.
• Do not attach the speakers using nails or two-sided tape. Vibration during use may cause the nails to loosen, tape to peel off and
speakers to fall, resulting in injury.
• CinemaStation may fall over if your feet or hands get caught in the speaker cable. Make sure the cables are fixed in place.
• After attaching everything, check the overall safety of your installation.
YAMAHA will bear no responsibility for accidents caused by improperly placed equipment or faulty installation methods.
54
Non-skid pad
1
/
to
5
/
)
8
32
3
/
)
4
13
10 mm (
/
)
32
You can place the Front Speakers and Surround Speakers
on the floor or a rack, or attach them to a wall. You can also
mount them on commercially available speaker stands.
As shown in the picture, attach the non-skid pads on the bottoms
of the Front and Surround Speakers in the four corners. This
stabilizes the speakers to prevent sliding.
* Place on a stable, flat surface.
Attach to the wall using the two holes on the back of the Front and
Surround Speakers.
Attach 2 screws (3.5 to 4 mm (
commercially available) to each place you want
to hang a Front or Surround Speaker.
Hang the speakers on the screws using the
holes in the back of each speaker.
Note
• Make sure that the tapping screw enters the narrow part of the hole
and the speaker is fixed securely in place.
1
5
/
to
/
) dia.,
8
32
Werbung
Kapitel
Inhaltsverzeichnis
