Recording Audio From Cinemastation - Yamaha DVX-S120 Bedienungsanleitung

Using Other Equipment
Notes on recording and playing audio

Recording Audio from CinemaStation

POWER
POWER
/DTS
NIGHT
DVD/CD
MOVIE
Advice
• When using Timer Playback/Recording, even if CinemaStation is in standby mode, the memory content (input source, AM/FM
frequency) is retained and used.
Note
• Even if you use DTS software to digitally record a DTS signal only noise will be recorded.
• If you want to perform Timer Recording without hearing sound, turn the volume down before starting Timer Recording.
52
DVR-S120 WB56650
POWER
TV
AUDIO ANGLE SUBTITLE
SELECT MATRIX 6.1 STEREO
REPEAT A-B
SW CENTER SURR
SHIFT
AMP
VCR VIDEO
Input
Selection
TUNER
buttons
MUSIC SPORTS GAME
CINEMA
• Perform a test recording before recording.
• It is not possible to record DSP effects.
• When you turn off the connected CD recorder or MD recorder
power, playback sound may become distorted and the volume
reduced. In this case, turn on the CD recorder or MD recorder
power.
• Even if you adjust the audio volume, audio quality, or change
the DSP Program during a video recording, it has no effect on
the recorded sound. However, in DVD/CD mode, the output
sound for recording may cut off if any of the operations below
are performed. Do not perform any of the below during
recording.
— Output a test tone.
— Change a DSP Program
— Connect/disconnect the headphones
• CinemaStation can output a signal from the DIGITAL IN jack
to the DIGITAL OUT jack. The signal input from the
DIGITAL IN jack cannot output from the analog output jacks,
and the signal input from the analog input jacks cannot output
from the DIGITAL OUT jacks.
• Audio recordings that you make cannot be used for any
purpose other than private enjoyment without the consent of
the copyright holder.
Timer Playback/Recording
Combined with a commercially available audio timer, you can
perform Timer Playback and Timer Recordings.
Operations vary depending on the equipment and audio timer
used, so be sure to read the relevant equipment owner's manual.
Turn on the CD recorder or MD recorder power
and get ready for recording.
Press POWER to turn on CinemaStation.
Switch CinemaStation input to the source you
want and start playback.
Ex. To play a CD: First press DVD/CD then play the CD.
Start recording with the CD recorder or MD
recorder.