Cleaning; Service - Parkside PGG 15 A1 Originalbetriebsanleitung

Operation / Cleaning / Service
Using very light pressure, guide the engraving point
workpiece. Find the ideal speed of movement by trial and error on
a piece of waste material.
Note: The engraving point
from tungsten steel. Therefore it is not suitable for engraving electronic
media such as CDs, DVDs etc. It could damage these materials and
render them illegible.

Cleaning

work, always remove the mains plug from the socket.
Clean all the dirt off the device. Use a dry cloth for cleaning.

Service

vice centre or by qualified specialist personnel using
original manufacturer parts only. This will ensure that your
device remains safe to use.
always have the replacement carried out by the man-
ufacturer or its service centre. This will ensure that your device
remains safe to use.
16 GB
supplied with the product is made
5
Before performing any cleaning or maintenance
Have your device repaired at the ser-
If the plug or lead needs to be replaced,
over the
5