Settings; Change Settings; Offset; Zero The Pressure - Pce Instruments Pce-Hvac 4 Bedienungsanleitung

5.3

Settings

Use the settings menu to change the settings for the offset, sleep mode or the Bluetooth mode.
The pressure gauge will remember your settings.
Option

Offset

Bluetooth

Sleep mode
hen the device is in the settings menu, the display will show "S TUP". Hold the "Setup" key
for three seconds to enter or leave the settings mode.
5.3.1

Change settings

Use the "Units ▲" or "Units▼" keys to navigate to that setting that needs to be
-
changed.
Press " nter" to choose the corresponding setup option.
-
Press "Units ▲" or "Units▼" to put in the desired setting.
-
Press " nter" to save your changes.
-
5.3.2 Offset
The primary display shows the temperature in correlation with the offset. You can save
individual offsets for T1 and T2.
5.3.3

Zero the pressure

If the pressure sensor needs to be calibrated with the atmospheric pressure, you need to make
sure that the instrument is away from any pressure sources and in balance with the atmospheric
pressure. Press and hold the "Hold"-key for three seconds and the instrument will set the zero
point on the amount of the environmental pressure.
5.3.4

Automatic shutdown

If the sleep mode is activated, the pressure gauge will shut itself down after 30 minutes of
inactivity. In order to activate or deactivate the sleep mode, you need to go into the settings
menu and then press the "Units ▲" and "Units▼" key to go to the submenu "SLP". Then press
" nter" and you will be able to choose between "On" and "Off". Hit " nter" to save your changes.
5.3.5 Bluetooth
hen the device is in the settings menu you can use the "Units ▲" and "Units▼" to reach the
submenu "bt". Press " nter" to be able to choose between "On" and "Off". Use the "Units ▲"
and "Units▼" keys to choose your setting. Your choice can be saved by pressing " nter" again.
The Bluetooth module has been designed that both these accessories can be connected:
- MFi: Made for iPhone / iPad / iPod
- SPP: Bluetooth standard
It transfers data with a 2,4 GHz ISM band and it is compatible with the Bluetooth core
specifications version 3.0 +EDR. The pressure gauge can send data to Android and iOS
devices.
Menu item
Offset
bt
SLP
© PCE Instruments
Settings
T1 or T2
On (Bluetooth activated)
Off (Bluetooth deactivated)
On (sleep mode activated)
Off (sleep mode deactivated)