Function Keys - Pce Instruments Pce-Hvac 4 Bedienungsanleitung

3.2

Function keys

Key Description
„Power" key
„Max / Min" key
„P1/P2" key
„Hold" key
„T1/T2" key
„Setup" key
„Units▲" key
„Units▼" key
„ nter" key
Function
Hit the power key to switch on / off the instrument.
Hit the key to switch between the maximum,
minimum and average function. To end that mode
you need to press the key for three seconds. The
device will then switch into normal measurement
mode.
Hit the key to switch between P1, P2 and P1-P2.
Hit the key to freeze the displayed value. When you
are done the freezing function can be disabled by
pressing the key again. Hold the key for three
seconds to zero the atmospheric pressure.
Hit the key to switch between T1, T2 and T1-T2.
Hit the key to activate or deactivate the backlight
function. Hold the key for three seconds to start or
end the settings menu.
Hit the key to change the pressure unit. When in the
settings menu, the key can be used to scroll or to
increase values.
Hit the key to change the pressure unit. When in the
settings menu, the key can be used to scroll or to
decrease values.
Hit the key to start an option within the settings. Hit
it again to save the shown value.
© PCE Instruments