Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
I
Connecting water supply hose
• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 - 10.0 kgf / cm
• Do not strip or crossthread when connecting inlet hose to the valve.
• If the water supply pressure is more than 1000 kPa, a decompression device should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
❿¤Step1 : Check rubber seal inlet hose
Hose connector
❿¤Step2 : Connect hose to water tap
Type-A : Connecting Screw-type hose to tap with thread
12
Rubber seal
Hose connector
Rubber seal
• Two rubber seals are supplied with the
water inlet hoses.
They are used for preventing water leaks.
Make sure the connection to taps is
sufficiently tight.
• Screw the hose connector onto water
supply tap.
2
).
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
