General Information About The Supplied Grinding Tool; Storage And Handling; Before Using The Grinder; Using Accessories - Parkside PWS 125 A1 Betriebsanleitung

♦ Place the rough grinding or cutting disc on the
mounting fl ange
the appliance.
♦ Then replace the tensioning nut
ing spindle with the raised side facing up.
♦ Press the spindle locking button
mechanism.
♦ Tighten the tensioning nut
ner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must immediately
be replaced.
♦ For safety's sake, run at high idle for 60
seconds after every disc change. Be aware of
unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fi tted.
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
General information about the
supplied grinding tool
■ Grinding tools are very fragile. Extreme care is
required when handling grinding tools.
■ Check grinding tools and brushes for damage
prior to initial use. Do not use damaged, incor-
rectly clamped or incorrecty installed grinding
tools.
■ Follow the safety instructions on the grinding
tools as well as the restrictions on use or safety
instructions.

Storage and handling

■ Grinding tools are to be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical da-
mage or environmental infl uences (e.g. moisture).
PWS 125 A1
with the label side towards
on the mount-
to lock the
using the span-

Before using the grinder

■ You should subject grinding tools to a visual
inspection before each use.
■ Do not use grinding tools if they are damaged
or if the expiration date has elapsed.

Using accessories

Cutting/rough grinding discs

You can use the following cutting/rough grinding
discs on this appliance:
Dimensions:
Rotational speed:
Circumferential speed:
Flap buff er discs for metal
Dimensions:
Rotational speed:

Additional accessories

You can also use the grinding tools below with the
following technical data:
Spindle thread:
Rotational speed:
Support plate for
sanding sheets with
dimensions:
ø 125 x 22.2 mm to
max. 6 mm thick (off set)
min. 12000 rpm
80 m/sec
ø 125 mm
min. 12000 rpm
M14
min. 12000 rpm
ø 115 mm/125 mm
27
GB