Using The Additional Handle; Switching On And Off; Setting The Rotational Speed; Changing Grinding Tools - Parkside PWS 125 A1 Betriebsanleitung

RISK OF INJURY!
► Always use the angle grinder with the blade
guard . The blade guard should be installed
securely. Set it so that the highest possible
degree of safety is achieved, i.e. the smallest
GB
possible part of the grinding disc is exposed
to the operator (see Figs. C, D). The blade
guard is designed to protect the operator
from fragments and accidental contact with
the grinding tool. The blade guard has 5 stop
positions.
► Turn the blade guard
(working position).
The closed side of the blade guard
always be toward the operator.

Using the additional handle

CAUTION!
► For safety reasons this appliance may only
be used with the additional handle
The additional handle
the left or the right depending on the work
method.
Switching on and off
Check the accessory tool before use. It must be
properly installed, may not be damaged or damp,
should have no cracks and turn freely. Carry out
a 60 second test run. Do not use non-circular or
vibrating tools. Be aware of unusual noises and
sparks. Check whether all the fastening elements
are correctly installed.
Switching on:
♦ Press the safety lock-out
♦ Press the ON/OFF switch
Switching off :
♦ Let go of the ON/OFF switch
26
to the required position
must
.
can be screwed on
.
.
.

Setting the rotational speed

♦ Select the desired speed as needed. Turn the
rotational speed preselector adjusting wheel
to the required setting. The required rotational
speed depends on the material being processed
and can be determined through practical tests.
The following table lists suggested settings for
the most common applications. Not all of the
accessories described are included in the
delivery.
Rotation speed preselection:
Material Use
Plastic, Polishing
lacquer
Finishing
Metal Finishing
Paint
removal
Wood, Brushes,
Metal Rust removal
Metal Grinding
Metal Roughing
Metal Cutting

Changing grinding tools

Always wear protective gloves when
changing cutting/rough grinding discs.
♦ Press the spindle locking button
the mounting spindle
still (see Fig. A).
♦ Press the spindle locking button
mechanism.
♦ Undo the tensioning nut
(see Fig B).
Tool Ad-
justing
wheel
Lamb's 1
wool hood
Felt polish- 1
ing disc
Buffi ng 1
wheel
Sanding 2–3
disc
Cup brush, 3
Sanding
disc
Grinding 4–6
disc
Roughing 6
disc
Cutting 6
disc
only when
is at a complete stand-
to lock the
using the spanner
PWS 125 A1