Charging The Battery; Removing / Inserting The Battery; Recharging The Battery - Parkside PWSA 18 A1 Originalbetriebsanleitung

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry room
only.
Prior to attaching the charger, check
that the battery's outer surface is
clean and dry.
There is a risk of injury due to elec-
tric shock.
Only use the original charger from
the package to charge the battery.
Mind not to charge the appliance
for more than 1 hours at a time. If
you do, the battery and the appli-
ance may be damaged and longer
charging times would be a waste
of energy. Excessive charging will
void the warranty.
Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
• Charge the battery before the first time
of use. Do not briefly charge the battery
several time in a row.
• Recharge the battery when you notice
that the appliance is becoming slower.
• If a fully recharged battery lasts for con-
siderably shorter operating times, the bat-
tery is used up and needs to be replaced.
Only use an OEM spare battery available
from our Customer Service.
• Always take heed of the applicable safety
instructions as well as the environmental
protection regulations and information.
• The warranty excludes all defects
caused by improper handling.
Removing / inserting the
battery
1. To remove the battery (9) from
the appliance, press the release
button 10) on the battery and
pull out the battery.
2. To insert the battery (9), place it
on the guide track and push it
back into the appliance. It will
audibly snap in.

Recharging the battery

1. Remove the battery (9) from the
appliance.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger.
3. Plug the battery charger into a
mains outlet.
4. When the battery (9) is fully
recharged unplug the battery
charger from the mains.
5. Pull the battery (9) out of the bat-
tery charger.
Green LED flashes without battery
Green LED lights up
Battery such alleged charged
Red LED lights up
Green LED flashes with battery:
Battery has to be charged in advance for
30 minutes before charging starts
Red and green LED flashes
Red and green LED lights up
Battery too cold or too warm. Battery can-
not be charged
GB IE
Charger ready
Battery charging
Battery defect
17